-
English
-
The eight molding points of the injection molding process (necessary for newcomers)
Generally injection molding machines can be operated manually, as well as semi-automatically and fully automatically.
-
The most detailed explanation of the injection molding process
The correction of the measuring stroke will increase the injection pressure to 99%, and temporarily adjust the holding pressure to 0, and then adjust the measuring end S0 forward to short shot, and th
-
How much do you know about injection molding?
Before injection molding, the plastic must be fully dried. After the moisture-containing material enters the mold cavity, silver-like blemishes will appear on the surface of the part, and even the phe
-
Knowing these 79 basic points of injection molding, it must be an injection molding expert.
The runner should be as wide and short as possible, and the gate position should be set according to the contraction and condensation process, and a cold material well should be added if necessary.
-
Master injection injection notes summarized by master for many years, craft setting standards
taken into account when setting, it will cause the raw materials to decompose due to the high temperature of the runner plate to produce water filaments, or the point gate temperature will be too low
-
The most complete injection molding technical parameters in history
K rubber injection molding technical parameters Drying temperature (℃) Generally do not need to dry If it is wet, it needs to be dried below 65 ℃ for about 1 hour
